Previous Page Next Page Prior Version PDF Version Table of Content DFARS Home Page PGI 207.1

subpart 207.1--acquisition plans

(Revised September 8, 2006)



 207.103 Agency-head responsibilities.
 207.105 Contents of written acquisition plans.
 207.106 Additional requirements for major systems.
 207.170 Consolidation of contract requirements.
 207.170-1 Scope.
 207.170-2 Definitions.
 207.170-3 Policy and procedures.
 207.171 Component breakout.
 207.171-1 Scope.
 207.171-2 Definition.
 207.171-3 Policy.
 207.171-4 Procedures.

207.103  Agency-head responsibilities.


      (d)(i)  Prepare written acquisition plans for—


                    (A)  Acquisitions for development, as defined in FAR 35.001, when the total cost of all contracts for the acquisition program is estimated at $10 million or more;


                    (B)  Acquisitions for production or services when the total cost of all contracts for the acquisition program is estimated at $50 million or more for all years or $25 million or more for any fiscal year; and


                    (C)  Any other acquisition considered appropriate by the department or agency.


              (ii)  Written plans are not required in acquisitions for a final buy out or one-time buy.  The terms "final buy out" and "one-time buy" refer to a single contract that covers all known present and future requirements.  This exception does not apply to a multiyear contract or a contract with options or phases.


      (e)  Prepare written acquisition plans for acquisition programs meeting the thresholds of paragraphs (d)(i)(A) and (B) of this section on a program basis.  Other acquisition plans may be written on either a program or an individual contract basis.


      (g)  The program manager, or other official responsible for the program, has overall responsibility for acquisition planning.


      (h)  For procurement of conventional ammunition, as defined in DoDD 5160.65, Single Manager for Conventional Ammunition (SMCA), the SMCA will review the acquisition plan to determine if it is consistent with retaining national technology and industrial base capabilities in accordance with 10 U.S.C. 2304(c)(3) and Section 806 of Pub. L. 105-261.  The department or agency--


              (i)  Shall submit the acquisition plan to the address in PGI 207.103(h) (Pop-up Window or PGI Viewer Mode) and


              (ii)  Shall not proceed with the procurement until the SMCA provides written concurrence with the acquisition plan.  In the case of a non-concurrence, the SMCA will resolve issues with the Army Office of the Executive Director for Conventional Ammunition.


207.105  Contents of written acquisition plans.

In addition to the requirements of FAR 7.105, planners shall follow the procedures at PGI 207.105 (Pop-up Window or PGI Viewer Mode).


207.106  Additional requirements for major systems.


      (b)(1)(A)  The contracting officer is prohibited by 10 U.S.C. 2305(d)(4)(A) from requiring offers for development or production of major systems that would enable the Government to use technical data to competitively reprocure identical items or components of the system if the item or component were developed exclusively at private expense, unless the contracting officer determines that—


                    (1)  The original supplier of the item or component will be unable to satisfy program schedule or delivery requirements;


                    (2)  Proposals by the original supplier of the item or component to meet mobilization requirements are insufficient to meet the agency's mobilization needs; or


                    (3)  The Government is otherwise entitled to unlimited rights in technical data.


              (B)  If the contracting officer makes a determination, under paragraphs (b)(1)(A)(1) and (2) of this section, for a competitive solicitation, 10 U.S.C. 2305(d)(4)(B) requires that the evaluation of items developed at private expense be based on an analysis of the total value, in terms of innovative design, life-cycle costs, and other pertinent factors, of incorporating such items in the system.


207.170  Consolidation of contract requirements. 


207.170-1  Scope.

This section implements 10 U.S.C. 2382.


207.170-2  Definitions.

As used in this section—


“Consolidation of contract requirements” means the use of a solicitation to obtain offers for a single contract or a multiple award contract to satisfy two or more requirements of a department, agency, or activity for supplies or services that previously have been provided to, or performed for, that department, agency, or activity under two or more separate contracts.


“Multiple award contract” means—


     (1)  Orders placed using a multiple award schedule issued by the General Services Administration as described in FAR Subpart 8.4;


     (2)  A multiple award task order or delivery order contract issued in accordance with FAR Subpart 16.5; or


     (3)  Any other indefinite-delivery, indefinite-quantity contract that an agency enters into with two or more sources for the same line item under the same solicitation.


207.170-3  Policy and procedures.


      (a)  Agencies shall not consolidate contract requirements with an estimated total value exceeding $5,000,000 unless the acquisition strategy includes—


              (1)  The results of market research;


              (2)  Identification of any alternative contracting approaches that would involve a lesser degree of consolidation; and


              (3)  A determination by the senior procurement executive that the consolidation is necessary and justified. 


                    (i)  Market research may indicate that consolidation of contract requirements is necessary and justified if the benefits of the acquisition strategy substantially exceed the benefits of each of the possible alternative contracting approaches.  Benefits may include costs and, regardless of whether quantifiable in dollar amounts—


                            (A)  Quality;


                            (B)  Acquisition cycle;


                            (C)  Terms and conditions; and


                            (D)  Any other benefit.


                    (ii)  Savings in administrative or personnel costs alone do not constitute a sufficient justification for a consolidation of contract requirements unless the total amount of the cost savings is expected to be substantial in relation to the total cost of the procurement.


      (b)  Include the determination made in accordance with paragraph (a)(3) of this section in the contract file.


207.171  Component breakout.


207.171-1  Scope.


      (a)  This section provides policy for breaking out components of end items for future acquisitions so that the Government can purchase the components directly from the manufacturer or supplier and furnish them to the end item manufacturer as Government-furnished material.


      (b)  This section does not apply to—


              (1)  The initial decisions on Government-furnished equipment or contractor-furnished equipment that are made at the inception of an acquisition program; or


              (2)  Breakout of parts for replenishment (see Appendix E).


207.171-2  Definition.

“Component,” as used in this section, includes subsystems, assemblies, subassemblies, and other major elements of an end item; it does not include elements of relatively small annual acquisition value.


207.171-3  Policy.

DoD policy is to break out components of weapons systems or other major end items under certain circumstances.


      (a)  When it is anticipated that a prime contract will be awarded without adequate price competition, and the prime contractor is expected to acquire any component without adequate price competition, the agency shall break out that component if—


              (1)  Substantial net cost savings probably will be achieved; and


              (2)  Breakout action will not jeopardize the quality, reliability, performance, or timely delivery of the end item.


      (b)  Even when either or both the prime contract and the component will be acquired with adequate price competition, the agency shall consider breakout of the component if substantial net cost savings will result from—


              (1)  Greater quantity acquisitions; or


              (2)  Such factors as improved logistics support (through reduction in varieties of spare parts) and economies in operations and training (through standardization of design).


      (c)  Breakout normally is not justified for a component that is not expected to exceed $1 million for the current year's requirement.


207.171-4  Procedures.

Agencies shall follow the procedures at PGI 207.171-4 (Pop-up Window or PGI Viewer Mode). for component breakout.




Previous Page Next Page Prior Version PDF Version Table of Content DFARS Home Page PGI 207.1