Previous Page Next Page Prior Version PDF Version Table of Content PGI

SUBPART 209.2--QUALIFICATIONS REQUIREMENTS

(Revised September 30, 2005)

 

 



 209.202 Policy
 209.270 Aviation critical safety items.
 209.270-1 Scope.
 209.270-2 Definitions.
 209.270-3 Policy
 209.270-4 Procedures


209.202  Policy
.

 

      (a)(1)  Except for aviation critical safety items, obtain approval in accordance with PGI 209.202(a)(1) (Pop-up Window or PGI Viewer Mode) when establishing qualification requirements.  See 209.270 for approval of qualification requirements for aviation critical safety items.

 

209.270  Aviation critical safety items.

 

209.270-1  Scope.

This section—

 

      (a)  Implements Section 802 of the National Defense Authorization Act for Fiscal Year 2004 (Pub. L. 108-136); and

 

      (b)  Prescribes policy and procedures for qualification requirements in the procurement of aviation critical safety items and the modification, repair, and overhaul of those items.

 

209.270-2  Definitions.

As used in this section—

 

“Aviation critical safety item” means a part, an assembly, installation equipment, launch equipment, recovery equipment, or support equipment for an aircraft or aviation weapon system if the part, assembly, or equipment contains a characteristic any failure, malfunction, or absence of which could cause—

 

      (1)  A catastrophic or critical failure resulting in the loss of or serious damage to the aircraft or weapon system;

 

      (2)  An unacceptable risk of personal injury or loss of life; or

 

      (3)  An uncommanded engine shutdown that jeopardizes safety.

 

“Design control activity” means the systems command of a military department that is specifically responsible for ensuring the air worthiness of an aviation system or equipment in which an aviation critical safety item is to be used.

 

209.270-3  Policy.

 

      (a)  The head of the contracting activity responsible for procuring an aviation critical safety item may enter into a contract for the procurement, modification, repair, or overhaul of such an item only with a source approved by the head of the design control activity.

 

      (b)  The approval authorities specified in this section apply instead of those otherwise specified in FAR 9.202(a)(1), 9.202(c), or 9.206-1(c), for the procurement, modification, repair, and overhaul of aviation critical safety items.

 

209.270-4  Procedures.

 

      (a)  The head of the design control activity shall—

 

              (1)  Identify items that meet the criteria for designation as aviation critical safety items.  See additional information at PGI 209.270-4. (Pop-up Window or PGI Viewer Mode)

 

              (2)  Approve qualification requirements in accordance with procedures established by the design control activity; and

 

              (3)  Qualify and identify aviation critical safety item suppliers and products.

 

      (b)  The contracting officer shall—

 

              (1)  Ensure that the head of the design control activity has determined that a prospective contractor or its product meets or can meet the established qualification standards before the date specified for award of the contract;

 

              (2)  Refer any offers received from an unapproved source to the head of the design control activity for approval.  The head of the design control activity will determine whether the offeror or its product meets or can meet the established qualification standards before the date specified for award of the contract; and

 

              (3)  Refer any requests for qualification to the design control activity.

 

      (c)  See 246.407(S-70) and 246.504 for quality assurance requirements.

 

 

 

 

 


Previous Page Next Page Prior Version PDF Version Table of Content PGI